DIY Wall Mount Side Table

Hey all! I am Caitlin, of The Merrythought, together with I am thus excited to hold upwards sharing a DIY amongst all of you lot hither on today! Lately I convey been working on updating my living room past times decluttering together with adding to a greater extent than or less useful but elementary DIY projects. This i mightiness simply hold upwards my favorite thus far!

What you’ll need:
-Two pieces of hardwood (I used oak) 14″ x seven 1/4″ x 3/4″ together with 14″ x 1 1/4″ x 3/4″
-Two modest pieces of plywood 2 3/8″ x 1 7/8″ x 3/16″ together with seven 1/4″ x 2 1/4″ x 3/16″
-5 brusque screws (1 5/8″)
-1 long screw (2 1/2″)
-Miterbox saw
-Super glue/Wood glue

How to brand it:
-Use your saw to cutting both ends of the long, sparse slice of oak (which volition hold upwards the back upwards underneath) at 45 marking angles.
-Stain all iv pieces of forest together with allow them dry out according to the directions of your stain.

-Attach the larger slice of plywood to the dorsum of the tabular array past times drilling ii holes through the plywood large plenty for the screw to become through thus trace it upwards on the dorsum of the board together with drill ii airplane pilot holes inward the dorsum of the oak thus screw the ii screws inward identify through these holes.
-Drill ii holes through that plywood underneath where it is attached to the oak – these volition hold upwards where the screws become into the wall later.

-Use the gum to attach the smaller slice of plywood to the bottom of the angled forest thus drill a hole through both – where a screw volition become through into the wall later.
-Drill a hole through the tiptop of the angled slice that is slightly wider thus your screw together with attach it to the bottom of your tabular array past times laying your table, amongst the tiptop on the flooring together with dorsum side (the plywood) against a wall, centre your back upwards slice on the bottom of the tabular array tiptop amongst the plywood slice sitting apartment against the wall, thus attach amongst a brusque screw.
-Now you lot tin purpose ii brusque screws through the large plywood to attach it to the wall together with the long screw to attach the bottom back upwards to the wall. Make certain your tabular array is bird earlier screwing it in.

Mine has already gotten a lot of purpose belongings my drinks together with snacks since this corner of the couch is my favorite location for belatedly black blogging. Try it out. I promise you lot bask yours equally much equally I exercise mine!

Caitlin is i of the iii minds behind The Merrythought. There they portion amongst you lot yummy recipes, inspiring DIY projects, fashionable clothes, lovely homes, pretty parties, together with bits of their trouble solid unit of measurement life.

Follow her:

Hosting Unlimited Indonesia